| About |
|---|
| Desmoderm TXC ENB-01 is a one-component polyester urethane based on an aromatic diisocyanate.&& |
| Product Description | |
|---|---|
| Supplier | Covestro |
| Generic | PUR-酯 |
| Material Status | Commercial: Active |
| Features | Good bond,Low temperature toughness,Soft |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| viscosity | |||
| 23℃ | 0.005 to 0.015 | Pa·s | DIN EN ISO 3219/A.3 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| film thickness | |||
| test | 100 | µm | |
| Tensile modulus | |||
| 100%，100 µm | 5.00 | MPa | DIN 53504 |
| tensile strength | DIN 53504 | ||
| 100 µm | 45.0 | MPa | DIN 53504 |
| 100 µm | 40.0 | MPa | DIN 53504 |
| 100 µm | 35.0 | MPa | DIN 53504 |
| 100 µm | 10.0 | MPa | DIN 53504 |
| Tensile strain | |||
| Fracture, 100 µ m | 550 | % | DIN 53504 |
| Fracture, 100 µ m | 100 | % | DIN 53504 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Light fastness | 2.00 | DIN EN ISO 105-B02 | |
| Softening range | 145 to 160 | ℃ | |
| Volume expansion | |||
| Acetone：23℃ | 110 | % | |
| Ethanol：23℃ | 20 | % | |
| Ethyl Acetate：23℃ | 130 | % | |
| Methyl Ethyl Ketone：23℃ | 190 | % | |
| Toluene：23℃ | 100 | % |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 25% solution in dimethyl formamide/methyl ethyl ketone (3:2) |
| 3. after 28 days hydrolysis |
| 4. after 400 hr Xenotest |
| 5. after 14 days hydrolysis |
| 6. 2 hr |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |