| About |
|---|
| injection molding grade; modified with ABS; good low-temperature flexibility; good wear resistance; Application; Ski boot shells; Injection molded engineering parts&& |
| Product Description | |
|---|---|
| Supplier | Covestro |
| Generic | TPU |
| Material Status | Commercial: Active |
| Features | Low temperature toughness,Good wear resistance |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.20 | g/cm³ | ISO 1183 |
| elastic body | Nominal value | Unit | Test method |
|---|
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore D, 1 second, 23 ℃ | 59 | ISO 7619 | |
| tensile strength | |||
| Fracture, 23 ℃ | 52.0 | MPa | |
| 10% strain, 23 ℃ | 13.0 | MPa | |
| 100% strain, 23 ℃ | 25.0 | MPa | |
| 300% 应变, 23°C | 44.0 | MPa | |
| Tensile strain | |||
| Fracture, 23 ℃ | 430 | % | DIN 53504 |
| Bending modulus | |||
| 23℃ | 230 | MPa | ISO 178 |
| Tensile storage modulus | |||
| -20℃ | 1.75 | GPa | |
| 20℃ | 0.500 | GPa | |
| 60℃ | 0.160 | GPa | |
| 35.0 | mm³ | ISO 4649 | |
| 42 | % | ISO 4662 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 100 to 110 | °C | |
| Processing (melt) temperature | 235 to 245 | °C | |
| Mold temperature | 40 to 50 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 7.9 in/min |
| 3. 0.079 in/min |
| 4. Method A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |