| About |
|---|
| injection molding grade; no yellowing under the action of UV light; improved microbial resistance; good low-temperature flexibility; Improved hydrolysis resistance; Application; automotive interior applications&& |
| Product Description | |
|---|---|
| Supplier | Covestro |
| Generic | TPU |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Hydrolysis stability,Antimicrobial properties,Low temperature toughness |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.13 | g/cm³ | ISO 1183 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 85 | ISO 868 | |
| Compression deformation | 18 | % | ISO 815 |
| abrasion resistance | 28 | mm³ | ISO 4649 |
| Tensile strain | 820 | % | DIN 53504 |
| tensile strength | 31 | MPa | DIN 53504 |
| Tensile modulus | 86 | MPa | ISO 6721-1,-4 |
| IMPACT | 63 | % | ISO 4662 |
| tear strength | |||
| MD | 75 | KN/m | ISO 34-1 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | <80 | °C | |
| Injection temperature | |||
| Rear barrel temperature | 180-190 | °C | |
| Central temperature of the barrel | 190-200 | °C | |
| Barrel front temperature | 200-210 | °C | |
| Die temperature | 200-210 | °C | |
| Mold temperature | 20-40 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 7.9 in/min |
| 3. Method A |
| 4. 20 in/min |
| 5. Method C |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |