| About |
|---|
| Devlon Nylon 12 is a Polyamide 12 (Nylon 12) material. It is available in Europe. Primary attribute of Devlon Nylon 12: Flame Rated.&& |
| Product Description | |
|---|---|
| Generic | PA12 |
| Material Status | Commercial: Active |
| Features | V-2 |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.03 | g/cm³ | ASTM D792 |
| Water absorption rate | ASTM D570 | ||
| 24hr | 1.0 | % | ASTM D570 |
| saturated | 1.6 | % | ASTM D570 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 1800 | MPa | ASTM D638 |
| tensile strength | |||
| 23℃ | 52.0 | MPa | ASTM D638 |
| Tensile strain | ASTM D638 | ||
| Yield, 23 ℃ | 13 | % | ASTM D638 |
| fracture | 240 | % | ASTM D638 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | ASTM D648 | ||
| 0.45 MPa, unannealed | 140 | ℃ | ASTM D648 |
| 1.8 MPa, unannealed | 50.0 | ℃ | ASTM D648 |
| Melting temperature | 175 | ℃ | ASTM D3418 |
| Linear coefficient of thermal expansion | |||
| MD：30~100℃ | 1.0E-4 | 1/℃ | ASTM E831 |
| Operating temperature | ASTM D570 | ||
| — | 80 | ℃ | ASTM D570 |
| short-term | 140 | ℃ | ASTM D570 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | 33 | kV/mm | ASTM D149 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | V-2 | UL 94 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Long Term |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |