| About |
|---|
| Skived Ultra High Molecular Weight Polyethylene film (UHMW) UHMW has extremely high abrasion resistance, exceeding the abrasion resistance of steel. This coupled with broad chemcial resistance and low coefficient of friction makes UHMW an extremely versatile engineering material for many severe service applications. Application examples include inner and outer surfaces for potable water, chemical, fule and hydraulic hoses, bottom surfaces for skis and snow boards as well as linings for chutes to decrease friction and wear. Also widely used in automotive weatherstrip applications to reduce friction&& |
| Product Description | |
|---|---|
| Generic | Ultra-high molecular weight polyethylene |
| Material Status | Commercial: Active |
| Features | Low coefficient of friction,Ultra high molecular weight,Good Tensile Strength,Good wear resistance,Solvent resistance |
| Availabilitys | North America,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.930 | g/cm³ | |
| Water absorption rate | |||
| saturated | 0.010 | % | |
| Thickness | 76.2 to 1570 | nm | |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| MD, yield | 41.4 | MPa | ASTM D882 |
| Tensile strain | |||
| MD, fracture | 300 | % | ASTM D882 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, annealed | 95.0 | ℃ | ISO 75-2/A |
| Melting temperature | 135 | ℃ | |
| Linear coefficient of thermal expansion | |||
| MD | 2.0E-4 | 1/℃ | ASTM D696 |
| Thermal conductivity coefficient | |||
| 23℃ | 0.063 | W/m/K | |
| deformation | |||
| 50℃ | 6.0 to 8.0 | % |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | 39 | kV/mm | ASTM D149 |
| Dielectric constant | 2.30 | ASTM D150 | |
| Dissipation factor | 4.0E-4 | ASTM D150 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Core ID | 7.62 | cm | |
| Core Type | Upon Request | ||
| Maximum Roll OD | 356 | mm | |
| Width | 6.35 to 1220 | mm |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2000 psi, 6 hr |
| 3. (2H 10e6 HZ) |
| 4. (increments of 1/16″), Metric Widths Available upon request |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |