| About |
|---|
| DIAMALOY ASAPC GLY 130 GF10 is a Polycarbonate + ASA (PC+ASA) product. It is available in North America. Characteristics include: REACH Compliant RoHS Compliant WEEE Compliant UV Stabilized&& |
| Product Description | |
|---|---|
| Generic | ASA+PC |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.25 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 265℃，5.0kg | 17 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Bending modulus | 2930 | MPa | ASTM D790B |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 3.2mm | 120 | J/m | ASTM D256-A |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed, 6.35 mm | 113 | ℃ | ASTM D648 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 82.2 to 93.3 | °C | |
| Drying time | 2.0 to 4.0 | hr | |
| Recommended maximum moisture content | 0.10 | % | |
| Recommended injection volume | 40 to 70 | % | |
| Barrel rear temperature | 230 to 260 | °C | |
| Barrel middle temperature | 232 to 265 | °C | |
| Barrel front temperature | 235 to 272 | °C | |
| Nozzle temperature | 220 to 272 | °C | |
| Processing (melt) temperature | 220 to 272 | °C | |
| Mold temperature | 40.0 to 80.0 | °C | |
| Injection speed | 快速 | ||
| Back pressure | 0.517 to 1.03 | MPa | |
| Notes |
|---|
| 1. This is an experimental grade only. |
| 2. Typical properties: these are not to be construed as specifications. |
| 3. Procedure A |
| 4. Method I (3 point load), 0.050 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |