| About |
|---|
| General grade for molding and extrusion This product has good processability. The rubber for molding is vulcanized with 2,5-Dimethyl-2,5-di(tert-butylperoxy)hexane as vulcanizator, applicable to manufacturing of common silicone rubber products and miscellaneous parts, common silicone rubber keypads, especially pigmented products; and the rubber for extrusion is vulcanized with vulcanizator DCBP (Di-(2,4-dichlorobenzoyl) Peroxide), applicable to manufacturing of low-end miscellaneous extruded silicone rubber products.&& |
| Product Description | |
|---|---|
| Supplier | DONGJUE |
| Generic | 硅酮 |
| Material Status | Commercial: Active |
| Features | Good coloring |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.10 to 1.20 | g/cm³ | ASTM D1505 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 47 to 53 | ASTM D2240 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile permanent deformation | < 10 | % | ASTM D412 |
| tensile strength | |||
| yield | > 7.00 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | > 320 | % | ASTM D412 |
| tear strength | > 18.0 | kN/m | ASTM D624 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Die B |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |