| About |
|---|
| Product Description | |
|---|---|
| Supplier | TEIJIN |
| Generic | Polycarbonate |
| Material Status | Commercial: Active |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.31 | g/cm³ | ISO 1183 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 65 | MPa | ISO 527 |
| fracture | 50 | MPa | ISO 527 |
| Tensile strain | |||
| yield | 6 | % | ISO 527 |
| fracture | 20 | % | ISO 527 |
| bending strength | 100 | MPa | ISO 178 |
| Bending modulus | 3900 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | 20 | kJ/m² | ISO 179 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa | 130 | ℃ | ISO 75 |
| Linear coefficient of thermal expansion | |||
| MD | 0.5 | 1.0E-4/℃ | ISO 11359-2 |
| TD | 0.5 | 1.0E-4/℃ | ISO 11359-2 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 1.0 mm | V-1 | UL 94 | |
| 1.5 mm | V-0 | UL 94 |
| Process Conditions | |||
|---|---|---|---|
| injection molding | Nominal value | Unit | Test method |
| Forming temperature | 270-300 | ℃ | |
| Mold temperature | 80-120 | ℃ | |
| Injection pressure | 98-147 | MPa | |
| drying temperature | 120 | ℃ | |
| Drying time | 5-8 | hr | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |