| About |
|---|
| DURAFIDE® 6165A7S is a Polyphenylene Sulfide (PPS) product filled with 65% glassmineral. It is available in Africa & Middle East, Asia Pacific, Europe, Latin America, or North America. Primary characteristic: chemical resistant.&& |
| Product Description | |
|---|---|
| Supplier | Polyplastics |
| Generic | PPS |
| Material Status | Commercial: Active |
| Features | Solvent resistance |
| Availabilitys | North America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.98 | g/cm³ | ISO 1183 |
| Water absorption rate | |||
| 23℃，24hr | 0.01 | % | ISO 62 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| 23℃ | 140 | MPa | ISO 527-2 |
| Tensile strain | |||
| 23 ℃, fracture | 1.10 | % | ISO 527-2 |
| bending strength | |||
| 23℃ | 205 | MPa | ISO 178 |
| Bending modulus | |||
| 23℃ | 17000 | MPa | ISO 178 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, annealed | 270 | ℃ | ISO 75-2/Af |
| Linear coefficient of thermal expansion | |||
| MD | 2.0E-5 | 1/℃ | ISO 11359-2 |
| TD | 3.0E-5 | 1/℃ | ISO 11359-2 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric constant | |||
| 23℃ | 5.40 | 1 kHz | IEC 60250 |
| 23℃ | 5.40 | 1 MHz | IEC 60250 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | |||
| 23℃ | 5.00 | kJ/m² | ISO 179/1eA |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |