Durethan® BKV30H2.0EF 900116

About

Product Description
SupplierLANXESS
GenericPA6
Material StatusCommercial: Negative
FeaturesHeat Stabilized,Good liquidity
AvailabilitysLatin America,North America
Process MethodsInjection Molding

Technical Data
PHYSICALNominal valueUnitTest method
Density1.40g/cm³ISO 1183
Apparent density0.60g/cm³ISO 60
Shrinkage rate
TD:120℃,2.0 mm0.14%
TD:280℃,2.0 mm0.70%
MD:120℃,2.0 mm0.050%
MD:280℃,2.0 mm0.23%

MECHANICALNominal valueUnitTest method
Tensile modulus
23℃9500MPaISO 527-1-2
tensile strength
Fracture, 23 ℃155MPaISO 527-2/5
Tensile strain
Fracture, 23 ℃2.9%ISO 527-2/5

IMPACTNominal valueUnitTest method
Charpy Unnotch Impact strength
-30℃50kJ/m²
23℃65kJ/m²
Impact strength of cantilever beam notch
-30℃< 10kJ/m²
23℃10kJ/m²
Notched impact strength of cantilever beam
-30℃50kJ/m²
23℃60kJ/m²

THERMALNominal valueUnitTest method
Hot deformation temperature
0.45 MPa, unannealed220ISO 75-2/B
1.8 MPa, unannealed205ISO 75-2/A
Linear coefficient of thermal expansion
MD:23~55℃2.0E-51/℃
TD:23~55℃9.0E-51/℃

Supplementary informationNominal valueUnitTest method
ISO ShortnameISO 1874-PA 6,MHR,12-090,GF30 

Process Conditions
InjectionNominal valueUnitTest method
Drying temperature – Dry Air Dryer80°C
Drying time – Dry Air Dryer2.0 to 6.0hr
Processing (melt) temperature270 to 290°C
Mold temperature80 to 120°C
Residual Moisture Content0.030 to 0.12%Karl Fisher

Notes
【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.