| About |
|---|
| Durethan® C38FAM 000000 (Dry) PA 6-Copolymer, non-reinforced, extrusion, suitable for food-contact&&Durethan® C38FAM 000000 PA 6-Copolymer, non-reinforced, extrusion, suitable for food-contact&&Durethan® C38FAM 000000 PA 6-Copolymer, non-reinforced, extrusion, suitable for food-contact&& |
| Product Description | |
|---|---|
| Supplier | Envalior |
| Generic | PA6 |
| Material Status | Commercial: Active |
| Features | Copolymer |
| Availabilitys | North America,Asia Pacific,Africa & Middle East ,Europe,Latin America |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.13 | g/cm³ | ISO 1183 |
| Melt Volume Rate | |||
| 235℃，2.16 kg | 5.00 | cm³/10min | ISO 1133 |
| Water absorption rate | |||
| Saturation, 23 ℃ | 10 | % | ISO 62 |
| Equilibrium, 23 ℃, 50% RH | 3.0 | % | ISO 62 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | 212 | ℃ | ISO 11357-3 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | — | ohms | IEC 60093 |
| Volume resistivity | |||
| 23℃ | — | ohms·cm | IEC 60093 |
| Dielectric strength | |||
| 23 ℃，1 mm | — | kV/mm | IEC 60243-1 |
| Relative permittivity | |||
| 23℃，1 MHz | — | IEC 60250 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| ISO Shortname | PA 6/IPDI,ES, 18-020 | ISO 1874 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying Temperature – Dry Air Dryer | 80 | °C | |
| Drying Time – Dry Air Dryer | 2.0 to 6.0 | hr | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 10°C/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |