Edgetek™ PA-50GF/000 BK004

About
Glass Fiber Reinforced PPA Compound.&&

Product Description
Supplier	Polyone
Generic	PA 66+PA 6I/6T
Material Status	Commercial: Negative
Features	HB
Availabilitys	Asia Pacific
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.63	g/cm³	ISO 1183
Shrinkage rate	0.20 to 0.50	%	ASTM D955

MECHANICAL	Nominal value	Unit	Test method
tensile strength	230	MPa	ISO 527-2
Bending modulus	16800	MPa	ISO 178
bending strength	320	MPa	ISO 178

IMPACT	Nominal value	Unit	Test method
Charpy Notched Impact Strength
23℃	11	kJ/m²	ISO 179

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed, 3.2 mm	285	℃	ASTM D648

Electrical performance	Nominal value	Unit	Test method
Surface resistivity	1.0E+15	ohms	ASTM D257

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
1.60 mm	HB		Internal Method

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	80 to 120	°C
Drying time	4.0 to 6.0	hr
Barrel rear temperature	320 to 340	°C
Barrel middle temperature	320 to 340	°C
Barrel front temperature	320 to 340	°C
Mold temperature	120 to 135	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.