| About |
|---|
| EL-LENE™ D795C is an Autoclave LDPE grade for extrusion coating/lamination.&& |
| Product Description | |
|---|---|
| Supplier | SCG |
| Generic | LDPE |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good surface appearance,Good heat sealing,Low shrinkage,Good bond,Low temperature heat sealing |
| Availabilitys | North America,Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.918 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 9.0 | g/10min | ASTM D1238 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 85.0 | ℃ | ASTM D1525 |
| Melting temperature | 107 | ℃ | ASTM D2117 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Melt temperature | 300 to 330 | °C | |
| Shrinkage 2 (315癈) | 60.0 | mm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Constant output at 50 rpm |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |