| About |
|---|
| Elastamax™ HTE Series thermoplastic elastomers (TPEs) are based upon compounded blends of PVC resins and nitrile rubber. These elastomeric materials provide outstanding resistance to hydrocarbons and oils, offer excellent weatherability, and are an economical alternative to thermoset rubber and other more costly thermoplastic elastomers.&& |
| Product Description | |
|---|---|
| Supplier | Polyone |
| Generic | PVC+NBR |
| Material Status | Commercial: Active |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.33 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，5.0kg | 0.46 | g/10min | ASTM D1238 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tear strength | 57.6 | kN/m | ASTM D624 |
| Compression deformation | ASTM D395A | ||
| 70℃，22 hr | 46 | % | ASTM D395A |
| 100℃，22 hr | 52 | % | ASTM D395A |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | -49.0 | ℃ | ASTM D746 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 15 seconds | 80 | ASTM D2240 | |
| tensile strength | ASTM D638 | ||
| fracture | 19.3 | MPa | ASTM D638 |
| 100% strain | 8.94 | MPa | ASTM D638 |
| 300% strain | 16.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 390 | % | ASTM D638 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Procedure A |
| 3. Type IV, 20 in/min |
| 4. Die C, 20 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |