| About |
|---|
| Thermoplastic Polyester-Polyurethane with excellent mechanical properties, outstanding wear resistance, high tear and tensile strength, good damping characteristic, high resilience performance and superior low temperature flexibility.&& |
| Product Description | |
|---|---|
| Supplier | BASF |
| Generic | TPU-酯 |
| Material Status | Commercial: Active |
| Features | Elastic,Good Tensile Strength,Low temperature toughness,Good tear strength,Good wear resistance |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.18 | g/cm³ | ISO 1183/A |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 3 seconds | 60 | ISO 7619 | |
| Wear amount | 100 | mm³ | ISO 4649-A |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 25.0 | MPa | DIN 53504-S2 |
| 300% strain | 6.50 | MPa | DIN 53504-S2 |
| 20% strain | 1.00 | MPa | DIN 53504-S2 |
| 100% strain | 2.50 | MPa | DIN 53504-S2 |
| Tensile strain | |||
| fracture | 900 | % | DIN 53504-S2 |
| tear strength | 45 | kN/m | ISO 34-1 |
| Compression deformation | ISO 815 | ||
| 23℃，72 hr | 25 | % | ISO 815 |
| 70℃，24 hr | 40 | % | ISO 815 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | ISO 179 | ||
| -30℃ | No Break | ISO 179 | |
| 23℃ | No Break | ISO 179 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 80 to 90 | °C | |
| Recommended maximum moisture content | 0.020 | % | |
| Hopper temperature | 40 | °C | |
| Barrel rear temperature | 175 to 185 | °C | |
| Barrel middle temperature | 180 to 195 | °C | |
| Barrel front temperature | 185 to 195 | °C | |
| Nozzle temperature | 190 to 200 | °C | |
| Processing (melt) temperature | 185 to 195 | °C | |
| Mold temperature | 20 to 40 | °C | |
| Injection speed | Slow | ||
| Back pressure | 5.00 to 15.0 | MPa | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Method Bb, Angle (Nicked) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |