| About |
|---|
| Thermoplastic Polyester Polyurethane Elastomers with excellent mechanical properties, very good damping and resilience performance, heat resistance and improved cycle times. Typical applications (Automotive) e.g. sealings, stop dampers, cable jackets.&& |
| Product Description | |
|---|---|
| Supplier | BASF |
| Generic | TPU-酯 |
| Material Status | Commercial: Active |
| Features | High Heat Resistance,Elastic |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.18 | g/cm³ | ISO 1183/A |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 3 seconds | 71 | ISO 7619 | |
| Wear amount | 50.0 | mm³ | ISO 4649-A |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | DIN 53504 | ||
| 300% strain | 4.50 | MPa | DIN 53504 |
| 20% strain | 1.50 | MPa | DIN 53504 |
| 100% strain | 2.50 | MPa | DIN 53504 |
| yield | 30.0 | MPa | DIN 53504 |
| yield | 40.0 | MPa | DIN 53504 |
| Tensile strain | DIN 53504 | ||
| fracture | 850 | % | DIN 53504 |
| fracture | 900 | % | DIN 53504 |
| tear strength | 45 | kN/m | ISO 34-1 |
| Compression deformation | ISO 815 | ||
| 23℃，72 hr | 25 | % | ISO 815 |
| 70℃，24 hr | 35 | % | ISO 815 |
| 100℃，24 hr | 50 | % | ISO 815 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | ISO 179 | ||
| -30℃ | No Break | ISO 179 | |
| 23℃ | No Break | ISO 179 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 90.0 | ℃ | ISO 306/A120 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion | Nominal value | Unit | Test method |
| Processing (melt) temperature | 190 to 220 | °C | |
| Mold temperature | 20 to 50 | °C | |
| Melt temperature | 180 to 230 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. after storage in water for 21 days at 80°C |
| 3. Method Bb, Angle (Nicked) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |