Elastollan® N 1190 A 10 U

About

Product Description
Supplier	BASF
Material Status	Commercial: Active
Features	Low temperature toughness,Hydrolysis stability

Technical Data
MECHANICAL	Nominal value	Unit	Test method
Shore hardness	90	Shore A	DIN ISO 7619-1
Tensile strength	45	MPa	DIN 53504-S2
Elongation at break	600	%	DIN 53504-S2
Tear strength	80	N/mm	DIN ISO 34-1Bb
	45	mm³	DIN ISO 4649-A

PHYSICAL	Nominal value	Unit	Test method
Density	1.13	g/cm³	DIN ISO 1183-1-A

Process Conditions
Injection molding	Nominal value	Unit	Test method
Drying time	2-3	h
Drying temperature	90-110	℃
Screw speed	< 0.2	m/s
Melt pressure	400-600	Bar
Injection speed	低速
Retention time of melt	<10	min

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.