Eltex® MED PH22D630

About
Low Density Polyethylene for Pharmaceutical Blow Moulding Benefits & Features Eltex® MED PH22D630 is a LD-polyethylene produced in a high-pressure process intended for blow moulding of soft and flexible packages for pharmaceutical products. Eltex® MED PH22D630 is produced according to good manufacturing practice and is additive-free. Eltex® MED PH22D630 is available in granular form. Applications Eltex® MED PH22D630 can be used in “blow-fill and seal” machines for the production ampoules and bottles. The product can also be used for pharmaceutical products manufactured with other conversion techniques such as injection moulding and film blowing. The product is not intended for heat sterilisation&&

About

Low Density Polyethylene for Pharmaceutical Blow Moulding Benefits & Features Eltex® MED PH22D630 is a LD-polyethylene produced in a high-pressure process intended for blow moulding of soft and flexible packages for pharmaceutical products. Eltex® MED PH22D630 is produced according to good manufacturing practice and is additive-free. Eltex® MED PH22D630 is available in granular form. Applications Eltex® MED PH22D630 can be used in “blow-fill and seal” machines for the production ampoules and bottles. The product can also be used for pharmaceutical products manufactured with other conversion techniques such as injection moulding and film blowing. The product is not intended for heat sterilisation&&

Product Description
Supplier	INEOS
Generic	LDPE
Material Status	Commercial: Active
Features	Good flexibility,Low density,Soft
Availabilitys	Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.922	g/cm³	ISO 1183
Melt Flow Rate
190℃，2.16kg	0.30	g/10min	ISO 1133

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	49		ISO 868
Tensile modulus	240	MPa	ISO 527-1-2
tensile strength
yield	10.0	MPa	ISO 527-2/50
Tensile strain
fracture	450	%	ISO 527-2/50

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	49.0	℃	ISO 75-2/B

Process Conditions
Extrusion	Nominal value	Unit	Test method
Melt temperature	160 to 200	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.