EMAC+® SP1305

About
EMAC resins adhere to and are compatible with a wide range of materials including paper, polyolefins, oriented polyolefins, polyesters, ionomers, PVdC, unplasticized PVC and other polar polymers. For use as heat seal layer, adhesive layer, or modifier for cost/performance enhancement. They are soft, pliable and tough at ambient and freezing temperatures and exhibit excellent ESCR. These polymers exhibit high solids fillability and compatibility with a wide range of polymers. This facilitates their uses as bases for all-purpose concentrates for addition to a wide spectrum of polymers. EMAC resins process like LDPE. EMAC+ Specialty Copolymers are produced under patented technology: US Patent 5804675.&&

About

EMAC resins adhere to and are compatible with a wide range of materials including paper, polyolefins, oriented polyolefins, polyesters, ionomers, PVdC, unplasticized PVC and other polar polymers. For use as heat seal layer, adhesive layer, or modifier for cost/performance enhancement. They are soft, pliable and tough at ambient and freezing temperatures and exhibit excellent ESCR. These polymers exhibit high solids fillability and compatibility with a wide range of polymers. This facilitates their uses as bases for all-purpose concentrates for addition to a wide spectrum of polymers. EMAC resins process like LDPE. EMAC+ Specialty Copolymers are produced under patented technology: US Patent 5804675.&&

Product Description
Supplier	Westlake Chemical
Generic	EMA
Material Status	Commercial: Active
Features	Good flexibility,Good heat sealing,Good bond,Soft,High ESCR
Availabilitys	North America,Asia Pacific

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.942	g/cm³	ASTM D1505
Melt Flow Rate
190℃，2.16kg	2.0	g/10min	ASTM D1238
Methacrylic acid content	20.0	wt%

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	37		ASTM D2240
tensile strength
fracture	11.0	MPa	ASTM D638
Tensile strain
fracture	820	%	ASTM D638

THERMAL	Nominal value	Unit	Test method
Embrittlement temperature	< -73.0	℃	ASTM D746
Vicat Softening Temp	50.0	℃	ASTM D1525
Melting peak temperature	96.0	℃	ASTM D3418

Notes
1. Typical properties: these are not to be construed as specifications.
2. Type IV, 20 in/min
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.