| About |
|---|
| Thermoplastic Elastomer&& |
| Product Description | |
|---|---|
| Supplier | EnCom |
| Generic | TPE |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Shore hardness | |||
| Shaw’s A | 12 | ASTM D2240 | |
| Tensile modulus | 0.552 | MPa | ASTM D638 |
| tensile strength | |||
| yield | 2.52 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 800 | % | ASTM D638 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Recommended maximum moisture content | 0.050 | % | |
| Barrel rear temperature | 121 to 166 | °C | |
| Barrel middle temperature | 149 to 171 | °C | |
| Barrel front temperature | 171 to 188 | °C | |
| Nozzle temperature | 171 to 199 | °C | |
| Processing (melt) temperature | 177 to 193 | °C | |
| Mold temperature | 10 to 21 | °C | |
| Back pressure | 0.00 to 0.621 | MPa | |
| Screw speed | 100 to 200 | rpm | |
| Vent depth | 0.013 to 0.025 | mm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |