EnviroPCABS 5080

About
EnviroPCABS 5080 is a Polycarbonate + ABS (PC+ABS) product. It can be processed by injection molding and is available in North America. Primary characteristic: impact resistant.&&

Product Description
Generic	PC+ABS
Material Status	Commercial: Active
Features	High impact resistance
Availabilitys	North America
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.12 to 1.15	g/cm³	ISO 1183
Melt Flow Rate
260℃，5.0kg	15 to 25	g/10min	ISO 1133
Shrinkage rate	0.50 to 0.70	%	Internal Method

MECHANICAL	Nominal value	Unit	Test method
tensile strength	> 48.0	MPa	ISO 527-2
Bending modulus	1900 to 2200	MPa	ISO 178

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch	480 to 640	J/m	ASTM D256
Drop hammer impact	> 36.2	J	Internal Method

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.