| About |
|---|
| Equinox® Silicone Putty Products are new silicone compounds (platinum catalyst) that can be easily mixed and applied by hand to a variety of surfaces. Equinox® Putty is mixed in equal amounts (1A:1B) by volume. Equinox® 35 has a pot life of about 1 minute with a cure time of about 7 minutes at room temperature (73°F/23°C). Equinox® 38 has a pot life of 4 minutes with a cure time of 30 minutes and Equinox® 40 is a slower version with a 30 minute pot life and 5 hour demold time. Shrinkage is low and cured rubber is exceptionally strong (very high tensile strength), durable and will resist high temperatures (for casting low-temperature melt metal alloys). They also resist cure inhibition. Equinox® Silicones are also FOOD SAFE and can be used for culinary applications. (See separate technical bulletin for usage instructions available at www.smooth-on.com).&& |
| Product Description | |
|---|---|
| Generic | 硅酮 |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Low contractility,Food contact compliance,High Heat Resistance,Good Tensile Strength,Durability |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | casting |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.25 | g/cm³ | ASTM D1475 |
| Specific volume | 0.768 | cm³/g | ASTM D1475 |
| Shrinkage rate | |||
| MD | 0.030 | % | ASTM D2566 |
| viscosity | Putty | ASTM D2393 | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 35 | ASTM D2240 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 3.59 | MPa | ASTM D412 |
| 100% strain | 0.820 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 430 | % | ASTM D412 |
| tear strength | 24.5 | kN/m | ASTM D624 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| storage stability | 1.0 | min | ASTM D2471 |
| stripping time | 7.0 | min |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Mixing ratio | 1A:1B by volume or weight |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Die B |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |