| About |
|---|
| Eraclene MS 80 U is a gas phase high density polyethylene resin (HDPE) with antioxidants, suitable for injection moulding application. This grade has a narrow molecular weight distribution and a high fluidity make it ideally for injection moulding applications. The polymer has high thermal stability during extrusion and a good balance between fluidity and mechanical properties. Main Application Eraclene MS 80 U is an injection moulding grade designed for thin-walled (food containers) aerosol caps.&& |
| Product Description | |
|---|---|
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | High liquidity,Food contact compliance,Inoxidizability,Weight distribution,High density,Heat Stabilized |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.955 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 27 | g/10min | ISO 1133 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| Compression Molding | 40 | J/m | ISO 180 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | < -60.0 | ℃ | ASTM D746 |
| Vicat Softening Temp | 126 | ℃ | ISO 306/A |
| Melting temperature | 135 | ℃ | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D, molded | 66 | ISO 868 | |
| tensile strength | ISO 527-2 | ||
| Yield, molding | 27.0 | MPa | ISO 527-2 |
| Fracture, molded | 10.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| Fracture, molded | 100 | % | ISO 527-2 |
| Bending modulus | |||
| Compression Molding | 1300 | MPa | ISO 178 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel rear temperature | 190 to 260 | °C | |
| Barrel middle temperature | 190 to 260 | °C | |
| Barrel front temperature | 190 to 260 | °C | |
| Mold temperature | 10 to 40 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Method A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |