| About |
|---|
| Colour : black Reinforcement : wood flour/inorganic Application areas : handles, technical pieces, housings, mounting-parts, covers Mark : DIN 31/1549&& |
| Product Description | |
|---|---|
| Generic | 酚醛树脂 |
| Material Status | Commercial: Active |
| Features | Renewable resources |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.40 | g/cm³ | ISO 1183 |
| Shrinkage rate | ISO 2577 | ||
| — | 0.60 to 0.80 | % | ISO 2577 |
| — | 0.40 to 0.60 | % | ISO 2577 |
| Water absorption rate | < 100.0 | mg | ISO 62 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| bending strength | > 70.0 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | > 1.3 | kJ/m² | ISO 179-1eA |
| Charpy Unnotch Impact strength | > 4.5 | kJ/m² | ISO 179/1eU |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | > 115 | ℃ | ISO 75-2/A |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | > 1.0E+8 | ohms | IEC 60093 |
| Volume resistivity | > 1.0E+10 | ohms·cm | IEC 60093 |
| Compared to the leakage tracing index | > 125 | V | IEC 60112 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | IEC 707 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Post-shrink |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |