About |
---|
An excellent choice for low-voltage power-and-cable control cables, this RoHS compliant, flexible, black colored thermoplastic CPE jacketing compound offers wire and cable manufacturers the advantages of thermoplastic extrusion processing without the need to invest in continuous vulcanizing (CV) equipment. CPE 30-33 RoHS Black is excellent for larger-diameter cables and co-extrusion strips for cable jacketing. Good heat/shock resistance, weatherability, moisture, oil and electrical properties as well as good processibility for high cable extrusion line speed.&& |
Product Description | |
---|---|
Supplier | Polyone |
Generic | CPE |
Material Status | Commercial: Active |
Availabilitys | North America,Latin America,Asia Pacific |
Technical Data | |||
---|---|---|---|
PHYSICAL | Nominal value | Unit | Test method |
Density | 1.31 | g/cm³ | ASTM D792 |
Melt Flow Rate | |||
190℃,21.6kg | 15 | g/10min | ASTM D1238 |
exterior | 颗粒/立方体 | ASTM D2090 |
THERMAL | Nominal value | Unit | Test method |
---|---|---|---|
Embrittlement temperature | -33.0 | ℃ | ASTM D746 |
FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
---|---|---|---|
Extreme oxygen index | |||
1.91 mm | 30 | % | ASTM D2863 |
MECHANICAL | Nominal value | Unit | Test method |
---|---|---|---|
Shore hardness | |||
Shaw’s D | 39 | ASTM D2240 | |
tensile strength | |||
fracture | 11.0 | MPa | ASTM D638 |
Tensile strain | |||
fracture | 450 | % | ASTM D638 |
Bending modulus | 6.41 | MPa | ASTM D790 |
Notes |
---|
1. Typical properties: these are not to be construed as specifications. |
2. Type IV, 20 in/min |
3. 0.50 in/min |
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |