Flexane® Brushable

About
A tough, rubber-like urethane compound for making a broad range of repairs to protect against wear, abrasion, and noise reduction. Intended Use: Protect equipment surfaces from wear and abrasion. Protect processing equipment such as coating hoppers, lining chutes, pump volutes, impellers, and fan housings. Product features: Bonds with primers to metal, concrete, rubber, wood, and fiberglass Excellent tear resistance Mixes easily Coats up to 50 mils in one pass Highly resistant to impact and abrasion&&

Product Description
SupplierDevcon
GenericPUR
Material StatusCommercial: Active
FeaturesGood flexibility,High impact resistance,Good tear strength,Good wear resistance
AvailabilitysNorth America

Technical Data
PHYSICALNominal valueUnitTest method
Specific volume0.939cm³/g
Shrinkage rate
MD23%ASTM D2566
Solid content
by Volume77%

elastic bodyNominal valueUnitTest method
tensile strength24.1MPaASTM D412
Tensile strain
fracture600%ASTM D412
tear strength70.1kN/mASTM D624

Electrical performanceNominal valueUnitTest method
Dielectric strength13kV/mmASTM D149

Uncured PropertiesNominal valueUnitTest method
Curing time18hr

MECHANICALNominal valueUnitTest method
Shore hardness
Shaw’s A86 ASTM D2240
Wear amount90.0mg/1000 cycles

THERMALNominal valueUnitTest method
Maximum operating temperature 
Dry82
Wet49
Thermosetting components 
resin按重量计算的混合比: 80 
Hardening method按重量计算的混合比: 20 
storage stability
24 ℃45min
Thermosetting mixed viscosity40000cP

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.