Flexirene® MR 50 A

About
Flexirene MR 50 A is a linear low density polyethylene (LLDPE) with antioxidants, suitable for injection moulding application. Parts made by Flexirene MR 50 A are characterised by optimum rigidity. Main Application Flexirene MR 50 A is recommended for the production of thin walled containers requiring high mechanical properties, lids, caps, closures, houseware and shock absorbers.&&

Product Description
Generic	Linear low density polyethylene
Material Status	Commercial: Active
Features	Good Rigidity,Food contact compliance,Inoxidizability,Low density
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.939	g/cm³	ISO 1183
Melt Flow Rate
190℃，2.16kg	22	g/10min	ISO 1133

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D, injection molding	56		ISO 868
tensile strength
Fracture, injection molding	15.0	MPa	ISO 527-2
Yield, injection molding	15.0	MPa	ISO 527-2
Tensile strain
Fracture, injection molding	> 500	%	ISO 527-2
Bending modulus
injection molding	500	MPa	ISO 178

THERMAL	Nominal value	Unit	Test method
Embrittlement temperature	< -70.0	℃	ASTM D746
Vicat Softening Temp	113	℃	ISO 306/A
Melting temperature	126	℃	Internal Method

Process Conditions
injection	Nominal value	Unit	Test method
Barrel rear temperature	170 to 230	°C
Barrel middle temperature	170 to 230	°C
Barrel front temperature	170 to 230	°C
Mold temperature	10 to 40	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.