| About |
|---|
| Fluon®PTFE granular powders (moulding powders) are used for the production of sheets, rods, billets and other general mouldings. Filled compounds are described in other page. Applications: large billet(300-1,500mm height) sheet moulding. feed stock. Characteristics: fine particle powders. high tensile strength excellent surface finish. higher bulk density for G190 and G192.&& |
| Product Description | |
|---|---|
| Supplier | Asahi Glass |
| Generic | PTFE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good surface appearance |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Apparent density | 0.33 | g/cm³ | JIS K6891 |
| Shrinkage rate | 4.2 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 42.0 | MPa | JIS K6891 |
| Tensile strain | |||
| fracture | 350 | % | JIS K6891 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Average particle size | 25.0 | µm | ASTM D1457 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Injection pressure | 16.0 | MPa | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |