Fluoraz 890 - SOLIAO

About
Fluoraz 890 is formulated for use in sanitary gaskets where both USP and FDA compliance is required, making it an excellent compound for both pharmaceutical and other hygienic fluid handling applications such as seals for brewery applications. Fluoraz 890 metal and TOC extractable are an orde of magnitude lower than premium competitive FKM formulations, ensuring little or no contamination into the process stream. Fluoraz 890 also meets the extrative requirements of both 21 CFR 177.2600 (e), (f) and 21 CFR 177.240 (d) extraction testing for perfluoroelastomers. Fluoraz 890 sanitary gaskets by Greene, Tweed are designed for minimal intrusion. Fluoraz 784 is also available in O-rings and custom shapes where a low durometer hardness is desired.&&

About

Fluoraz 890 is formulated for use in sanitary gaskets where both USP and FDA compliance is required, making it an excellent compound for both pharmaceutical and other hygienic fluid handling applications such as seals for brewery applications. Fluoraz 890 metal and TOC extractable are an orde of magnitude lower than premium competitive FKM formulations, ensuring little or no contamination into the process stream. Fluoraz 890 also meets the extrative requirements of both 21 CFR 177.2600 (e), (f) and 21 CFR 177.240 (d) extraction testing for perfluoroelastomers. Fluoraz 890 sanitary gaskets by Greene, Tweed are designed for minimal intrusion. Fluoraz 784 is also available in O-rings and custom shapes where a low durometer hardness is desired.&&

Product Description
Generic	PTFE
Material Status	Commercial: Active
Features	Low extract,Food contact compliance,Solvent resistance,Resistance to the steam
Availabilitys	North America

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.65	g/cm³	ASTM D297

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s A	80		ASTM D2240

elastic body	Nominal value	Unit	Test method
tensile strength			ASTM D412
fracture	17.9	MPa	ASTM D412
50% strain	5.86	MPa	ASTM D412
100% strain	11.7	MPa	ASTM D412
Tensile strain
fracture	180	%	ASTM D412
Compression deformation
204℃，70 hr	30	%	ASTM D395

THERMAL	Nominal value	Unit	Test method
Operating temperature	-5 to 232	℃

Notes
1. Typical properties: these are not to be construed as specifications.
2. 25% Deflection
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.