Formolene® 5143N

About
Formolene® 5143N is a higher melt flow polypropylene homopolymer designed for faster cycle time and excellent clarity. It contains a unique combination of stabilizers and nucleation that provide an excellent balance of stiffness and impact strength. Formolene® 5143N does not contain animal derived ingredients, and is suitable for high temperature food processing and preparation. Formolene® 5143N meets all requirements of the U. S. Food and Drug Administration as specified in 21 CFR 177.1520, covering safe use of polyolefin articles and components of articles intended for direct food contact. Additionally, it meets FDA requirements regarding retort food processing.&&

About

Formolene® 5143N is a higher melt flow polypropylene homopolymer designed for faster cycle time and excellent clarity. It contains a unique combination of stabilizers and nucleation that provide an excellent balance of stiffness and impact strength. Formolene® 5143N does not contain animal derived ingredients, and is suitable for high temperature food processing and preparation. Formolene® 5143N meets all requirements of the U. S. Food and Drug Administration as specified in 21 CFR 177.1520, covering safe use of polyolefin articles and components of articles intended for direct food contact. Additionally, it meets FDA requirements regarding retort food processing.&&

Product Description
Supplier	fpc-tw
Generic	PP homopolymerization
Material Status	Commercial: Active
Features	Good Clarity,High impact resistance,High liquidity,Quick molding cycle,Rigid-tough balance
Availabilitys	North America
Process Methods	Thermo forming

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.900	g/cm³	ASTM D1505
Melt Flow Rate
230℃，2.16kg	3.0	g/10min	ASTM D1238

MECHANICAL	Nominal value	Unit	Test method
tensile strength
yield	38.6	MPa	ASTM D638
Tensile strain
yield	7.0	%	ASTM D638
Bending modulus
1% secant	1720	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	43	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	118	℃	ASTM D648

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.