| About |
|---|
| Formolene FORMAX® L9 is a high strength linear low density polyethylene. Film mechanical properties are significantly improved compared to competitive super hexene LLDPE film resins. Formolene FORMAX® L9 is formulated with slip and antiblock for use in high performance film applications offering excellent extrusion processing and outstanding impact strength and tear resistance. Films exhibit superior sealing characteristics and good optical properties. Formolene FORMAX® L9 meets all requirements of the U.S. Food and Drug Administration as specified in 21 CFR 177.1520, covering safe use of polyolefin articles intended for direct food contact. Suggested Applications: Industrial Packaging Industrial Liners Food Packaging Can Liners Consumer Trash Bags Coextrusion&& |
| Product Description | |
|---|---|
| Supplier | fpc-tw |
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Good Rigidity,High impact resistance,Smoothness,Optical performance,High anti-blocking,Food contact compliance,Good tear strength,Hexene copolymers |
| Availabilitys | North America |
| Process Methods | Film extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.916 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 0.75 | g/10min | ASTM D1238 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| film thickness | |||
| test | 25 | µm | |
| tensile strength | |||
| TD, fracture, 25 µ m, blow molded film | 34.5 | MPa | ASTM D882 |
| TD, yield, 25 µ m, blow molded film | 10.5 | MPa | ASTM D882 |
| MD, fracture, 25 µ m, blow molded film | 39.3 | MPa | ASTM D882 |
| MD, yield, 25 µ m, blow molded film | 10.5 | MPa | ASTM D882 |
| Tensile strain | |||
| TD, fracture, 25 µ m, blow molded film | 880 | % | ASTM D882 |
| MD, fracture, 25 µ m, blow molded film | 670 | % | ASTM D882 |
| Drop hammer impact | |||
| 25 µ m, blow molded film | 540 | g | ASTM D1709 |
| tear strength | |||
| TD, 25 µ m, blow molded film | 650 | g | ASTM D1922 |
| MD, 25 µ m, blow molded film | 470 | g | ASTM D1922 |
| Initial sealing temperature | |||
| 50 µm | 100 | ℃ |
| Notes |
|---|
| 1. talc based |
| 2. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |