Formolene® L62009H

About
Formolene® L62009H is a general-purpose film grade linear low density made using gas-phase technology. The resin exhibits excellent toughness and strength when drawn down to thin gauges. Formolene® L62009H meets all requirements of the U.S. Food and Drug Administration as specified in 21 CFR 177.1520, covering safe use of polyolefin articles intended for direct food contact.&&

Product Description
Supplier	fpc-tw
Generic	Linear low density polyethylene
Material Status	Commercial: Active
Features	Good Rigidity,Ultra high toughness,Low density
Availabilitys	North America
Process Methods	Film extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.919	g/cm³	ASTM D1505
Melt Flow Rate
190℃，2.16kg	0.95	g/10min	ASTM D1238

film	Nominal value	Unit	Test method
film thickness
test	25	µm
tensile strength
TD, fracture, 25 µ m, blow molded film	24.0	MPa	ASTM D882
MD, fracture, 25 µ m, blow molded film	32.8	MPa	ASTM D882
Tensile strain
TD, fracture, 25 µ m, blow molded film	780	%	ASTM D882
MD, fracture, 25 µ m, blow molded film	520	%	ASTM D882
Drop hammer impact
25 µ m, blow molded film	160	g	ASTM D1709
tear strength
TD, 25 µ m, blow molded film	630	g	ASTM D1922
MD, 25 µ m, blow molded film	400	g	ASTM D1922

optical performance	Nominal value	Unit	Test method
gloss
45 °, 25 µ m, blow molded film	33		ASTM D523
Haze
25 µ m, blow molded film	21	%	ASTM D1003

Supplementary information	Nominal value	Unit	Test method
Blow（up Ratio）	2.5:1

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.