| About |
|---|
| Product Description | |
|---|---|
| Supplier | DS TECH |
| Generic | TPU |
| Material Status | Commercial: Active |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Shore hardness | |||
| Shaw’s A | 85 | ASTM D2240 | |
| Tensile strain | |||
| 500 mm/min | 490 | % | ASTM D412 |
| tensile strength | |||
| 500 mm/min | 300 | kg/cm² | ASTM D412 |
| tear strength | |||
| 500 mm/min | 130 | kg/cm² | ASTM D624 |
| Process Conditions | |||
|---|---|---|---|
| injection molding | Nominal value | Unit | Test method |
| drying temperature | 100-105 | ℃ | |
| Drying time | 3-4 | hr | |
| Mold temperature | 30-45 | ℃ | |
| Nozzle temperature | 195-210 | ℃ | |
| Measurement section temperature | 185-200 | ℃ | |
| Compression section temperature | 175-190 | ℃ | |
| Temperature of feed section | 165-180 | ℃ | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |