Glasforms™ 3000

About
0°/90°, E-glass fiber reinforced, thermoset polymer pultruded profiles (square and sheets)&&

Product Description
Supplier	Polyone
Generic	热固性复合材料
Material Status	Commercial: Active
Availabilitys	North America

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density
Curing treatment	1.80	g/cm³	ASTM D792

Supplementary information	Nominal value	Unit	Test method
Ash Content
Continuous glass fiber	55.0	%

MECHANICAL	Nominal value	Unit	Test method
Babbitt hardness	50 to 60		ASTM D2583
Tensile modulus	17900 to 24100	MPa	ASTM D638
tensile strength	310 to 414	MPa	ASTM D638
Bending modulus	14500 to 18600	MPa	ASTM D790
bending strength	448	MPa	ASTM D790
compressive strength	276	MPa	ASTM D695

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.