| About |
|---|
| 73204 TU is a Rotomolding grade LLDPE produced by the Spherilene Technology with controlled morphology, excellent balance of processability & mechanical properties 73204 TU is stabilized adequately with Light Stabiliser + to give a long service life under outdoor exposure. 73204 TU is ideally suited for Tanks and Containers for domestic and industrial water storage, sanitation and agriculture.&& |
| Product Description | |
|---|---|
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Excellent Processability |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.932 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 5.0 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Yield, injection molding | 17.0 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, injection molding | 900 | % | ASTM D638 |
| Bending modulus | |||
| injection molding | 550 | MPa | ASTM D790-A |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23 ℃, injection molding | 500 | J/m | ASTM D256-A |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 74.0 | ℃ | ASTM D648 |
| Vicat Softening Temp | 115 | ℃ | ASTM D1525 4 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Oven Temperature | 240 to 280 | ℃ |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 23°C |
| 3. 2.0 in/min |
| 4. Loading 1 (10 N) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |