Hanwha Total PP BI970

About
BI970 is a highly isotactic block copolymer with ultra-high flowability, high impact, and higher crystalinity compared to general PP. It maintains an optimum balance of strength and impact resistance due to high crystalline technology and the most appropriate rubber design. Through the control of molecular weight distribution, the product shows superior melt flow compared to normal PP and is appropriate for energy savings and multi-cavity injection molding. BI970 is useful in large scale thin products with low distortion tendencies and may also be used as a compound base resin.&&

About

BI970 is a highly isotactic block copolymer with ultra-high flowability, high impact, and higher crystalinity compared to general PP. It maintains an optimum balance of strength and impact resistance due to high crystalline technology and the most appropriate rubber design. Through the control of molecular weight distribution, the product shows superior melt flow compared to normal PP and is appropriate for energy savings and multi-cavity injection molding. BI970 is useful in large scale thin products with low distortion tendencies and may also be used as a compound base resin.&&

Product Description
Supplier	HANWHA
Generic	HC PP
Material Status	Commercial: Active
Features	Good Rigidity,High impact resistance,High liquidity,Crystal,High Heat Resistance,Block Copolymer,Weight distribution,low-temperature impact resistance
Availabilitys	North America,Asia Pacific
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.910	g/cm³	ASTM D1505
Melt Flow Rate
230℃，2.16kg	100	g/10min	ASTM D1238

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	59	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	125	℃	ASTM D648

optical performance	Nominal value	Unit	Test method
gloss	85		ASTM D2457

MECHANICAL	Nominal value	Unit	Test method
Rockwell hardness
R-level	87		ASTM D785
tensile strength
yield	31.4	MPa	ASTM D638
Tensile strain
fracture	25	%	ASTM D638
Bending modulus	1670	MPa	ASTM D790

Process Conditions
injection	Nominal value	Unit	Test method
Barrel rear temperature	160 to 200	°C
Barrel middle temperature	200 to 240	°C
Barrel front temperature	220 to 260	°C
Mold temperature	30 to 50	°C
Injection pressure	98.1 to 245	MPa
Hold pressure	78.5 to 226	MPa

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.