Hanwha Total PP HJ700

About
Description HJ700 is homo PP for injection molding application. The injection molded articles made from this grade offers high rigidity and heat resistance, excellent scratch resistance, and high surface gloss. Products of HJ700 ascertain pleasant and satisfying service quality due to substantially less odor from reduced volatile organic compounds. Characteristics High rigidity & Heat resistance Excellent scratch resistance & high surface gloss Excellent organoleptics & High purity (low VOC) Applications General purpose, Houseware&&

About

Description HJ700 is homo PP for injection molding application. The injection molded articles made from this grade offers high rigidity and heat resistance, excellent scratch resistance, and high surface gloss. Products of HJ700 ascertain pleasant and satisfying service quality due to substantially less odor from reduced volatile organic compounds. Characteristics High rigidity & Heat resistance Excellent scratch resistance & high surface gloss Excellent organoleptics & High purity (low VOC) Applications General purpose, Houseware&&

Product Description
Supplier	HANWHA
Generic	PP homopolymerization
Material Status	Commercial: Active
Features	Good Rigidity,Good surface appearance,Good liquidity,High Heat Resistance,High scratch resistance,Homopolymer
Availabilitys	North America,Asia Pacific
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.910	g/cm³	ASTM D1505
Melt Flow Rate
230℃，2.16kg	22	g/10min	ASTM D1238

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch			ASTM D256
0℃	20	J/m	ASTM D256
23℃	29	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	110	℃	ASTM D648
Vicat Softening Temp	155	℃	ASTM D1525 2

MECHANICAL	Nominal value	Unit	Test method
Rockwell hardness
R-level	100		ASTM D785
tensile strength
yield	37.3	MPa	ASTM D638
Tensile strain
fracture	250	%	ASTM D638
Bending modulus	1670	MPa	ASTM D790

Process Conditions
injection	Nominal value	Unit	Test method
Barrel rear temperature	170 to 200	°C
Barrel middle temperature	180 to 210	°C
Barrel front temperature	210 to 250	°C
Mold temperature	30 to 50	°C
Injection pressure	78.5 to 118	MPa
Hold pressure	58.8 to 98.1	MPa

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.