| About |
|---|
| Hepla® H9000MS is a polyphtalamide PPA product filled with Molybdenum Disulfide.Characteristics include: Lubricated,Creep Resistant,Heat Resistant. |
| Product Description | |
|---|---|
| Supplier | NFD |
| Generic | PPA |
| Material Status | Commercial: Active |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.21 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD：3.20 mm | 1.2 to 1.8 | % | ASTM D955 |
| water content | 0.05 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 3902 | MPa | ASTM D638 |
| tensile strength | 90.5 | MPa | ASTM D638 |
| Tensile strain | |||
| yield | 2.5 to 3.9 | % | ASTM D638 |
| Bending modulus | 3902 | MPa | ASTM D790 |
| bending strength | 168 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 3.20 mm | 47.3 | J/m | ASTM D256 |
| Notched impact strength of cantilever beam | |||
| 3.2 mm | 521 | J/m | ASTM D4812 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 1.5 mm | HB | UL 94 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 135 | ℃ | ASTM D648 |
| Process Conditions | |||
|---|---|---|---|
| Processing technology | Nominal value | Unit | Test method |
| Injection pressure | 68.9 to 124 | MPa | |
| Melt Temperature | 302 to 329 | ℃ | |
| Mold temperature | 135 to 163 | ℃ | |
| drying temperature | 107 | ℃ | |
| Drying time | 4 to 6 | hr | |
| Dew point temperature | -32 | ℃ | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |