| About |
|---|
| HFDK-4201 NT is an unfilled, crosslinkable, low density polyethylene insulation compound designed for medium voltage power cable insulation applications. HFDK-4201 NT has been designed to have a low level of additive bloom for a long storage life, low dusting and an enhanced degree of scorch retardance. HFDK-4201 NT is suitable for the insulation of power distribution cables. Specifications HFDK-4201 NT is designed for use in power distribution cables. Cables insulated with HFDK-4201 NT, using sound commercial manufacturing practice, would be expected to meet the latest editions of the following specifications and regulations: IEC 60502 UL 1072 CENELEC HD 620 S2 GB/T 12706 BSI BS 6622, 7870-4&& |
| Product Description | |
|---|---|
| Supplier | DOW |
| Generic | PE |
| Material Status | Commercial: Active |
| Availabilitys | Africa & Middle East ,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.920 | g/cm³ | ASTM D792 |
| humidity | < 200 | ppm | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 20.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 500 | % | ASTM D638 |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Change in Tensile Properties（7 days，135℃） | < 25 | % | ASTM D638 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| thermosetting | IEC 60811-2-1 | ||
| Elongation under load: 200 ℃ | < 100 | % | IEC 60811-2-1 |
| Elongation without load: 200 ℃ | < 10 | % | IEC 60811-2-1 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | |||
| 23℃ | > 1.0E+16 | ohms·cm | ASTM D257 |
| Dielectric strength | ASTM D149 | ||
| 3.18 mm | > 30 | kV/mm | ASTM D149 |
| 3.18 mm | > 23 | kV/mm | ASTM D149 |
| 3.18 mm | > 39 | kV/mm | ASTM D149 |
| Dielectric constant | |||
| 23℃ | 2.30 | ASTM D150 | |
| Dissipation factor | |||
| 23℃ | < 3.0E-3 | ASTM D150 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Method A (Short-Time) |
| 3. Method B (Step-by-Step) |
| 4. Method C (Slow Rate-of-Rise) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |