| About |
|---|
| Hostacom ETA5081 low melt flow, 490 MPa flexural modulus, blow molding grade thermoplastic elastomeric olefin (TEO) resin combines good processability with balanced strength, toughness and flexibility. It was designed for various under-the-hood applications.&& |
| Product Description | |
|---|---|
| Supplier | LyondellBasell |
| Generic | Polyolefin Elastomer |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good flexibility,Low liquidity,High impact resistance,Ductility |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.900 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 1.0 | g/10min | ASTM D1238 |
| 230℃，2.16kg | 1.0 | g/10min | ISO 1133 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 16.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| yield | 15 | % | ISO 527-2 |
| Bending modulus | 490 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 60 | kJ/m² | ISO 180 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Linear coefficient of thermal expansion | |||
| MD：-30~100℃ | 1.0E-4 | 1/℃ | ASTM E228 |
| MD：-30~100℃ | 1.0E-4 | 1/℃ | ISO 11359-2 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |