HR 181 - SOLIAO

About
g-ABS粉末与SAN颗粒复合如下。 g-ABS粉末（30％）+ SAN颗粒（70％）+ A / O

Product Description
Supplier	Kumho Petrochemical
Generic	ABS
Material Status	Commercial: Active

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Melt Flow Rate
200℃，21.6kg	24 ±3	g/10min	ASTM D1238

Other performance	Nominal value	Unit
Rubber content	57~ 60	%
Rubber particle size	3 ,000 ~ 4 ,000	Å
bulk density	0.35~0.4 0	g/cm 3
Powder particle size distribution
5 Mesh on	1	%
10 Mesh on	20	%
50 mesh on	74	%
100 mesh on	4	%
100 mesh pass	1	%

MECHANICAL	Nominal value	Unit	Test method
tensile strength
23℃	47 ±2	MPa	ASTM D638

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃，6.4mm	294 ±29.4		ASTM D256

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.