| About |
|---|
| Fluorous rubber (FKM-DS2600), commonly called 2# rubber, is white elastomer and copolymer of VDF and hexafluoropropylene, with fluorine content of over 66%. The product processed and vulcanized by raw fluorous rubber (DS2600), featured by good mechanical property and excellent oil resistance (fuels, synthetic oils, lubricating oils) and heat resistance, is an indispensable material for modern aviation, rocket, missile, space flight, and other top technologies and industries. Characteristic: Ultra-high Mooney viscosity Application: Compression molding parts, high-tenacity vulcanizing products&& |
| Product Description | |
|---|---|
| Supplier | Shenzhou |
| Generic | 氟橡胶 |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Gamma radiation,Corrosion Resistant,Ultra High Viscosity,High Heat Resistance,Copolymer,Grease resistance,Ozone resistance,Fuel resistance |
| Availabilitys | North America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.80 to 1.84 | g/cm³ | |
| Mooney viscosity | |||
| ML 1+10，121℃ | 121 to 200 | MU | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| — | > 11.5 | MPa | |
| — | > 9.50 | MPa | |
| Tensile strain | |||
| fracture | > 160 | % | |
| fracture | > 130 | % | |
| Compression deformation | |||
| 200℃，24 hr | < 25 | % |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Aged for 24 hr at 527°F |
| 3. Bisphenol AF, compression ratio 30% |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |