| About |
|---|
| Description Barrier thermoplastic, Nylon blend with HDPE Application Agrochemical Container,SORE* Fuel Tank, PFC&& |
| Product Description | |
|---|---|
| Supplier | LG Chemical |
| Generic | PA Not specified |
| Material Status | Commercial: Active |
| Features | Block resin |
| Availabilitys | North America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.960 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 0.35 to 0.40 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Yield, 3.20 mm | 25.0 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 3.20 mm | 260 | % | ASTM D638 |
| Bending modulus | |||
| 6.40 mm | 836 | MPa | ASTM D790 |
| bending strength | |||
| 6.40 mm | 31.5 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | ASTM D256 | ||
| -40℃，6.4mm | 67 | J/m | ASTM D256 |
| 23℃，6.4mm | 640 | J/m | ASTM D256 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Blow molding barrel temperature | 175 to 215 | ℃ | |
| Blow molding mold temperature | 175 to 215 | ℃ | |
| Blow Molding Melt Temperature | 200 to 230 | ℃ | |
| Blow Molding Mold Temperature | 30 to 50 | ℃ | |
| drying temperature | |||
| Blow Molding | 80 to 90 | ℃ |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Minimum Moisture Content – Blow Molding | < 0.010 | % | |
| Screw Speed – Blow Molding | 10 to 50 | rpm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 3. 0.39 in/min |
| 4. 3 to 4 hours |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |