| About |
|---|
| ICORENE® 3560 DW is a linear low density polyethylene specifically developed for rotational moulding. ICORENE® 3560 DW is a product specially formulated for applications that require contact with drinking water. This grade fulfils the requirements of health according to the German KTW Recommendation, the requirements of the growth of microorganisms according to the German DVGW-Arbeitsblatt W270 and the Attestation de Conformité Sanitaire (ACS) according to the French law.&& |
| Product Description | |
|---|---|
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Antimicrobial properties |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.935 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 5.0 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 50 ℃, 100% non-ionic surfactant | 30.0 | hr | ASTM D1693 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Falling impact resistance | |||
| -20℃ | 170 | J/cm | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 55 | ASTM D2240 | |
| tensile strength | |||
| yield | 17.0 | MPa | ASTM D638 |
| Bending modulus | 650 | MPa | ASTM D790 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |