| About |
|---|
| ICORENE™ 2018 is a low density polyethylene resin that is suitable for both carpet backing and binding of fibre and non-wovens. The high melt flow of this grade results in improved flow and ease of processing. ICORENE™ 2018 is available as a natural powder in a range of grind specifications to suit the application.&& |
| Product Description | |
|---|---|
| Generic | mHDPE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Weather resistance is good,Low warping,Good surface appearance,High impact resistance,High liquidity,Good Hardness,Quick molding cycle,Food contact compliance |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.947 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 4.5 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 100% non-ionic detergent | 80.0 | hr | ASTM D1693 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 20.4 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 620 | % | ASTM D638 |
| Bending modulus | 870 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Izod notched impact strength | |||
| -40℃，3.2mm | 102 | J | ARM |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| UV Rating | 8000 | hr | ASTM 2565 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |