INEOS LDPE 23L430

About
Additive free LDPE homopolymer extrusion coating and injection moulding product Benefits & Features 23L430 special polymer structure gives the following properties: Excellent draw down ability with adequate neck-in and stable edges Good process ability also at high line speeds and/or low coating weights Low fumes during extrusion Good adhesion on many substrates Good heat sealing properties Good organoleptical properties Low permeability to moisture and gases Good scratch resistance High purity and very low gel level Applications 23L430 is a low density polyethylene homopolymer for general coating applications. 23L430 coated substrates such as paper, board and aluminium can be used for packaging food and liquids, powders, medical devices, agricultural materials, chemicals and many other products.&&

About

Additive free LDPE homopolymer extrusion coating and injection moulding product Benefits & Features 23L430 special polymer structure gives the following properties: Excellent draw down ability with adequate neck-in and stable edges Good process ability also at high line speeds and/or low coating weights Low fumes during extrusion Good adhesion on many substrates Good heat sealing properties Good organoleptical properties Low permeability to moisture and gases Good scratch resistance High purity and very low gel level Applications 23L430 is a low density polyethylene homopolymer for general coating applications. 23L430 coated substrates such as paper, board and aluminium can be used for packaging food and liquids, powders, medical devices, agricultural materials, chemicals and many other products.&&

Product Description
Supplier	INEOS
Generic	LDPE
Material Status	Commercial: Active
Features	Excellent Processability,High purity,Good heat sealing,Good dissection,Low speed solidification point,Low odor,Good bond,Good sensory characteristics.,Poor moisture permeability,Low density,High scratch resistance,Homopolymer
Availabilitys	Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.924	g/cm³	ISO 1183
Melt Flow Rate
190℃，2.16kg	4.5	g/10min	ISO 1133

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp
A50	98.0	℃	ISO 306/A50
Melting temperature	113	℃	ISO 11357-3

Process Conditions
Extrusion	Nominal value	Unit	Test method
Melt temperature	280 to 325	°C

Notes
1. Typical properties: these are not to be construed as specifications.
2. DSC 2nd heating 10°C/min
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.