Ingeo™ 3052D

About
Ingeo biopolymer 3052D, a NatureWorks LLC product, is designed for injection molding applications where the requirements are clarity with heat deflection temperatures lower than 120°F (49°C). See table at right for typical properties. The variety of products made with Ingeo 3052D continues to grow rapidly. Applications include cutlery, cups, plates and saucers, and outdoor novelties, and this is just the beginning.&&

About

Ingeo biopolymer 3052D, a NatureWorks LLC product, is designed for injection molding applications where the requirements are clarity with heat deflection temperatures lower than 120°F (49°C). See table at right for typical properties. The variety of products made with Ingeo 3052D continues to grow rapidly. Applications include cutlery, cups, plates and saucers, and outdoor novelties, and this is just the beginning.&&

Product Description
Generic	PLA
Material Status	Commercial: Active
Features	Good Clarity,Good surface appearance,Renewable resources,Crystal,Biodegradable,Food contact compliance,Compostable
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.24	g/cm³	ASTM D792
Melt Flow Rate
210℃，2.16kg	14	g/10min	ASTM D1238
Shrinkage rate
MD	0.30 to 0.50	%
Relative viscosity	3.30

MECHANICAL	Nominal value	Unit	Test method
tensile strength
yield	62.1	MPa	ASTM D638
Tensile strain
fracture	3.5	%	ASTM D638
Bending modulus	3550	MPa	ASTM D790
bending strength	108	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch	16	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Glass transition temperature	55.0 to 60.0	℃	ASTM D3418
Crystallization peak temperature
DSC	145 to 160	℃	ASTM D3418

optical performance	Nominal value	Unit	Test method
transparency	Transparent

Process Conditions
injection	Nominal value	Unit	Test method
Recommended maximum moisture content	0.025	%
Hopper temperature	21	°C
Barrel rear temperature	166	°C
Barrel middle temperature	193	°C
Barrel front temperature	204	°C
Nozzle temperature	204	°C
Processing (melt) temperature	199	°C
Mold temperature	24	°C
Back pressure	0.345 to 0.689	MPa
Screw speed	100 to 175	rpm

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.