| About |
|---|
| Ingeo™ 3D850 is a grade developed for manufacturing 3D printer monofilament. This grade exhibits faster crystallization rates and is able to develop improved heat-resistance in 3D printed parts. This low color resin grade demonstrates the best performance in formulated systems designed to enhance toughness or heat-resistance. Monofilaments made with Ingeo 3D850 have excellent 3D printing characteristics such as precise detail, good adhesion to build plates, less warping or curling, and low odor.&& |
| Product Description | |
|---|---|
| Generic | PLA |
| Material Status | Commercial: Negative |
| Features | Low warping,Renewable resources,Crystal,Food contact compliance,Low odor,Good bond,Compostable |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.24 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 210℃，2.16kg | 7.0 to 9.0 | g/10min | ASTM D1238 |
| Relative viscosity | |||
| 30℃ | 4.00 | ASTM D5225 | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 2320 | MPa | ASTM D638 |
| tensile strength | 50.3 | MPa | ASTM D638 |
| MD, yield | 51.3 | MPa | ASTM D882 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile strain | |||
| MD, fracture | 3.3 | % | ASTM D882 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 120 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 80.0 to 90.0 | ℃ | ASTM E2092 |
| Glass transition temperature | 55.0 to 60.0 | ℃ | ASTM D3418 |
| Crystallization peak temperature | |||
| DSC | 165 to 180 | ℃ | ASTM D3418 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Barrel 1 zone temperature | 179 | °C | |
| Barrel 2 zone temperature | 191 | °C | |
| Barrel 3 zone temperature | 199 | °C | |
| Connector temperature | 199 | °C | |
| Melt temperature | 210 | °C | |
| Nozzle temperature | 199 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 1.0 g/dL in chloroform |
| 3. 3D printed part, 100% in-fill, annealed at 110°C/15 min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |