| About |
|---|
| Ingeo biopolymer 6260D, a NatureWorks product, is a thermoplastic fiber-grade resin derived primarily from annually renewable resources. Available in pellet form, 6260D is designed for melt blown fiber processing or extrusion into mechanically drawn staple fibers, using conventional fiber spinning and drawing equipment. 6260D is well suited for fiber processes where low boiling water fiber shrinkage and higher dimensional stability is required, in addition to low extrusion pressure. Ingeo biopolymer 6260D can be converted into a broad range of fiber products. Potential applications for Ingeo biopolymer 6260D include: Melt blown fiber Staple fiber Nonwovens Agricultural woven and nonwoven fabrics Articles for household disposal Textiles Spunbond fabrics&& |
| Product Description | |
|---|---|
| Generic | PLA |
| Material Status | Commercial: Negative |
| Features | Renewable resources,Food contact compliance,Compostable,Good stability |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Tensile strain | 10 to 70 | % | ASTM D2256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Glass transition temperature | 55.0 to 60.0 | ℃ | ASTM D3418 |
| Crystallization peak temperature | |||
| DSC | 165 to 180 | ℃ | ASTM D3418 |
| Hot air shrinkage | |||
| 10 min，130℃ | 4.00 to 5.00 | ASTM D2101 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Boiling Water Shrinkage | 3.0 to 4.0 | % | ASTM D2102 |
| Denier per Filament | > 0.500 | dpf | |
| Modulus | 30.0 to 55.0 | g/denier | ASTM D2256 |
| Tenacity | 2.00 to 4.00 | g/denier | ASTM D2256 |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 1.24 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 210℃，2.16kg | 65 | g/10min | ASTM D1238 |
| Relative viscosity | |||
| 30℃ | 2.50 | ASTM D5225 | |
| Melt density | |||
| 210℃ | 1.08 | g/cm³ |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Drying time | 4.0 to 6.0 | hr | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |