Ingeo™ 7032D

About
Ingeo biopolymer 7032D is a bottle grade resin designed for injection stretch blow molded applications where heat setting is needed. Ingeo biopolymer 7032D can be run on conventional and heat set ISBM equipment typically used for PET. Ingeo biopolymer 7032D is run at lower processing temperatures than PET. Injection stretch blow molded bottles (ISBM) for singe- and two-stage operations. Ideal for applications where heat setting is required, such as: Fruit juices Sports drinks Oils, jams, non-beverage&&

About

Ingeo biopolymer 7032D is a bottle grade resin designed for injection stretch blow molded applications where heat setting is needed. Ingeo biopolymer 7032D can be run on conventional and heat set ISBM equipment typically used for PET. Ingeo biopolymer 7032D is run at lower processing temperatures than PET. Injection stretch blow molded bottles (ISBM) for singe- and two-stage operations. Ideal for applications where heat setting is required, such as: Fruit juices Sports drinks Oils, jams, non-beverage&&

Product Description
Generic	PLA
Material Status	Commercial: Active
Features	Good Clarity,Good heat sealing,Renewable resources,Biodegradable,Food contact compliance
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.24	g/cm³	ASTM D792
Melt Flow Rate
210℃，2.16kg	7.0	g/10min	ASTM D1238
Shrinkage rate
MD	0.30 to 0.50	%	ASTM D955

film	Nominal value	Unit	Test method
Carbon dioxide transfer rate	2850	cm³/m²/24 hr	Internal Method
Oxygen permeability	675	cm³/m²/24 hr	ASTM D1434
Water vapor transmittance	380	g·mm/m²/atm/24 hr	ASTM F1249

THERMAL	Nominal value	Unit	Test method
Glass transition temperature	12.8 to 15.6	℃	ASTM D3417
Crystallization peak temperature
DSC	155 to 170	℃	ASTM D3418

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	65 to 85	°C
Drying time	4.0 to 6.0	hr
Recommended maximum moisture content	0.010	%
Barrel rear temperature	180	°C
Barrel middle temperature	210	°C
Nozzle temperature	210 to 220	°C
Processing (melt) temperature	200 to 220	°C
Mold temperature	21 to 38	°C
Back pressure	0.689 to 1.38	MPa

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.